Kriemhild mod reading wrong

[Flapopotamus]

Hi folks!

So had the Kriemhild mod a few months and loving it, no problems till this past week it keeps reading my brunhilde rdta at .22 ohms, but was initially reading it at the correct 0.1 and started switching, thought maybe a coil is loose and not registering properly. Tried the tank on my odin and that reads it fine, both coils are heating well with no issues.

Also tried manually reducing the ohms on the Kriemhild to 0.1/0.11 and it won't go any lower than 0.17.

Only other factor I can think of is I updated the firmware a few weeks ago and didn't really see any changes.

Anyone else had this problem?

Any help or suggestions appreciated, cheers folks!

 

[Mawsley]

I've been caning one of them since I got it. Last couple of weeks it keeps asking if I've put on a new atomiser and shifting the resistance reading.

Then yesterday, the second one started doing the same thing.

I think I need to hunt for a quality dual cell mod

 

[Flapopotamus]

I've been caning one of them since I got it. Last couple of weeks it keeps asking if I've put on a new atomiser and shifting the resistance reading.

Then yesterday, the second one started doing the same thing.

I think I need to hunt for a quality dual cell mod

Aye its done that a few times too! Shame cause it looks and feels great but I don't wanna retire it after like 5 months . Its not like its even been dropped, couple scratches here n there but that's it.

 

[Lee Parsons]

I got mine today. Been playing with it and checking the menu out. So I haven't used it apart from a couple of draws. I thought i check to see what it was like with 18650, and that's when i noticed a problem with the door not locking. When i slide the mod back onto the carriage, it didn't feel right. It closed but then pop open. It did this a number of times, so i decide to put back in the 21700 i had in it. It done it again. So i thought i throw in my other batteries just in case it was them. No luck there. So i look at where it was popping opening, at the bottom where spring load shutter is. If you look when you slide that back it moves some little metal catches back into the mod. I thought mine had probably got bent, and used my coiling rod to bend it back into the correct position. I had the coiling rod horizontal and push back on the metal catches. I did this for both of them as i didnt push to hard, in fear of breaking the metal.
Eventually after a number of times on each catch it lock. So if you have tis problem, this is the fix for it.

 

[PabloB]

I had this problem ohms changing all the time, getting no atomizer message.
Turned out the 3 screws fixing the 510 plate where loose from new.
One of these screws connect the ground wire.
Tightened these up and no problems so far.