Chuck Norris
Achiever
- Joined
- Mar 13, 2014
- Messages
- 1,938
My Vandy Vape Mesh turned up earlier, tried a couple different length SS mesh in here and it’s coming in at 0.16ohms now.
Running in TC mode on the Ipv6x haven’t had a dry hit....yet! (Dry hit on Mesh was pretty bad when I had it in my genesis tank years ago!!!) but I can’t feel TC kicking in here and I can taste when it’s a bit to have a dry hit! Need to play around with the settings....
Pretty good though, tried a few different cottons in here and have some cotton bacon v2 in it at the moment. Uses a fuck load of cotton!!!! Only gripe here is it leaks a fair bit so putting me off using it on my Pulse. Tried cutting the cotton right to the base, tried fluffing it up more, tried more cotton to cover the base but still leaks. Has anybody figured about a way of wicking this to cut down on leaks?
I’m using the Pulse & Dead Rabbit mainly now our and about and wanted to use the mesh but with hardly any juice well and the air holes are so low down I’m worried it’ll leak if I over squonk slightly, can see it being a pain trying to get juice up through the cotton to hit the mesh without it spilling out the airholes?
Running in TC mode on the Ipv6x haven’t had a dry hit....yet! (Dry hit on Mesh was pretty bad when I had it in my genesis tank years ago!!!) but I can’t feel TC kicking in here and I can taste when it’s a bit to have a dry hit! Need to play around with the settings....
Pretty good though, tried a few different cottons in here and have some cotton bacon v2 in it at the moment. Uses a fuck load of cotton!!!! Only gripe here is it leaks a fair bit so putting me off using it on my Pulse. Tried cutting the cotton right to the base, tried fluffing it up more, tried more cotton to cover the base but still leaks. Has anybody figured about a way of wicking this to cut down on leaks?
I’m using the Pulse & Dead Rabbit mainly now our and about and wanted to use the mesh but with hardly any juice well and the air holes are so low down I’m worried it’ll leak if I over squonk slightly, can see it being a pain trying to get juice up through the cotton to hit the mesh without it spilling out the airholes?
