Phantom Diablo
Achiever
- Joined
- Sep 16, 2013
- Messages
- 3,087
nothing fancy just dual coil builds and a variation on some existing ones
first up is a nano coil based on the dragon build with the tiny coils angled at 45 degrees upwards. however instead of the dragon coil wrap around the very small cotton wick is threaded inside the coil then goes between the postsive and negative post to sit on top of the opposite coil.
This build is on a smoktech scar which has the air holes in the bottom so by doing it this way gives plenty of clearance. resistance is 0.8 ohms and very intense vape with lots of plumes.
each coil is around 10-11 wraps and diameter of the coil is around 1mm and 2mm long.. if you know the smok scar you'll get an idea how small these are.. made using the blunt needle of syringe to wrap around
you can see in the image how much clearance there is from bottom of tank allowing for plenty of airflow
second up is on an IGO W so again you get idea of scale
this is 2 micro coils 10 wraps each giving 0.8 ohms
again coils are small diameter of around 1.5mm and set horizontally
however with this one i raised the coils very high above the deck almost above the posts then the wick is looped from the centre of the coil out and then back under the coil so it sets in the well allowing for plenty of juice while retaining lots of airflow.
again tons of plume and intense hit on this
it may look over wicked but actually because the wisk loops underneath its nice and airy
these both took about 10 minutes to make, using 0.32 kanthal and the usual cotton wool balls
first up is a nano coil based on the dragon build with the tiny coils angled at 45 degrees upwards. however instead of the dragon coil wrap around the very small cotton wick is threaded inside the coil then goes between the postsive and negative post to sit on top of the opposite coil.
This build is on a smoktech scar which has the air holes in the bottom so by doing it this way gives plenty of clearance. resistance is 0.8 ohms and very intense vape with lots of plumes.
each coil is around 10-11 wraps and diameter of the coil is around 1mm and 2mm long.. if you know the smok scar you'll get an idea how small these are.. made using the blunt needle of syringe to wrap around
you can see in the image how much clearance there is from bottom of tank allowing for plenty of airflow
second up is on an IGO W so again you get idea of scale
this is 2 micro coils 10 wraps each giving 0.8 ohms
again coils are small diameter of around 1.5mm and set horizontally
however with this one i raised the coils very high above the deck almost above the posts then the wick is looped from the centre of the coil out and then back under the coil so it sets in the well allowing for plenty of juice while retaining lots of airflow.
again tons of plume and intense hit on this
it may look over wicked but actually because the wisk loops underneath its nice and airy
these both took about 10 minutes to make, using 0.32 kanthal and the usual cotton wool balls
