micro coil russian 91%

[Phantom Diablo]

well after a few teething problems, all seems to be good now. 6 wrap .32mm kanthal and some cotton wool 1.2 ohms. steaming like a trooper

[[

 

[Rexer]

Looks good, will try that again soon, iv had a go with a dripper and wasn't keen on the flavour but I'm not sure if my cotton is bleached or not.

 

[Mason]

Cool, Same setup as mine. russian 91, microcoil and cotton.

I'm still not done fiddling with mine. Little tweaks. The current coil on mine works brilliantly but it's a little small (as in the diameter of the hole inside the coil, not the number of wraps etc) I'm going to have a play when I get home and try a microcoil wrapped around a slight thicker object.

 

[Chegs]

Near enough identical to my 91%'s build,with the most obvious difference being my coil is rotated further so it's probably 90 degrees to the screws.I'll alter the angle on the next coil though as I feel my coil position is possibly causing the cotton to interfere with the juice channels when the tank level is high(after filling)because it tends to give drier tasting hits.


I'm still suffering initial shocked expressions whenever I buy a new atty as I've seen them on youtube/pictures where they look larger,then buy it & open the box to find some microscopic screws/post holes etc.

 

[Rexer]

Near enough identical to my 91%'s build,with the most obvious difference being my coil is rotated further so it's probably 90 degrees to the screws.I'll alter the angle on the next coil though as I feel my coil position is possibly causing the cotton to interfere with the juice channels when the tank level is high(after filling)because it tends to give drier tasting hits.


I'm still suffering initial shocked expressions whenever I buy a new atty as I've seen them on youtube/pictures where they look larger,then buy it & open the box to find some microscopic screws/post holes etc.

I also feel my vape gear is a lot smaller than it looks on YouTube lol

Sent from my GT-I9300 using Planet of the Vapes mobile app

 

[jimthecarper]

Is this straight off the battery? Find mine a little "soft" at 1.2ohms. Maybe I need a smaller drill bit.