What's new

new to squonk, new to ohm law new to pico squezee

AdriaNocenzi

Postman
Joined
Sep 20, 2016
Messages
532
hi all,

as per tittle today i got the pico squezee i build with the stock coil which i believe are clapton, i use the samsung 25r, which are think are good for this? the battery are 1 years old, now how to i know how much WW i'm vaping? because i feel, quite weak, i usually vape around 40 w and this feel like 25 w.

Thanks
 
Well, there's this thing called Ohms Law, you might have been told about it on here.

If you'd measured the resistance of your coil ( did you do this at all before firing it up??) and used the max voltage output of an 18650 cell which is 4.2V, using the equation from Ohms law you'd have found the maximum power output capable from your set up.

Next, what atty are you using?
Is it a dual or single coil set up?

And, your clapton, what wire is it made up of?
 
yes i heard of the OHms law, i check steam machine but i didn't understand much, the coils are the one that come with the box, no i have not measure them before because i don't have the coil master, i used my x cube ultra and read 0.28, is the coral rda dual coil. the made of the clapton i don't know
 
Then go find out how to suss it out. there be plenty youtube videos on how to make comprehension easy. Fuck, if I can do it.....

The Coral is wank. It'll do if you don't have anything better, but it isn't the best bit of kit. If you like a more gentle vape then get a Hadly clone or, if you want a more rowdy vape, get a Wasp.
Claptons, most likely made from kanthal, will not be of any use on a single cell mod that is limited to 50W max output. Way too much metal to heat up. Get some plain 0.45 or 0.5mm 316 SS or some 0.5mm Ni80. That might get you something useful out of the atty.

Your xcube thing will do as an ohm reader, about the only use for a smok mod to be fair.
 
ok, thank i have my eye on wasp nano, and i have a 28 ga ss 316 l, so i guess i can use this wire for the next build, yes i found out the smok is rubbish i will invest on an coil
tester, as matter of fact which one to go for? and is the wire that i have good for it ?
 
I have also those I can use them?
1524578255116.jpg
 
Nothing stopping you trying them but remember the Squeeze limits watts to 50w.
Use the battery drain tab in SteamEngine to see what watts/amps each of those coils pulls & aim for 35/40w if you want decent battery life.
Personally I'd wait for the Wasp & use the 0.5ohm coils as that thing gets hot with low ohm coils.
 
Ok so as I rule I will not go down that 0.5 how much W will be at 0.5?
As for the wasp I still need to order it and know FT would take a month to arrive
 
Back
Top Bottom