Please help

[marcgee]

At the moment I have a Uwell crown with a ni200 coil in , I have locked the coil in at 0.17 ohm ,the temperature is set to 500f and the wattage is 50 watts all this is on my joyetech cuboid .what I need help is their is lots of vapour but not much taste I thought the Uwell was supposed to be good at flavour !!! If I put the same juice (80vg 20pg ) in my kangertech subtank with a 0.5 ohm coil and vape at 20 w I get more vapour and a lot more taste why is this ?

 

[ronzza]

try not to lock resistance as they fluctuate.
I would try 550F/60W and see what happens.
also check pin connection between the tank and mod.

 

[Mr Numpty]

try not to lock resistance as they fluctuate.

With most mods, including the Cuboid, you must lock in the resistance for the TC to work properly.

 

[ronzza]

I'm just reading my manual for my evic mini, I'm thinking its similar to cuboid.
from testing, I can lock it but it still fluctuate.

the manual says..
only lock when coil is in room temp
unlock before changing coil

 

[robotica]

You should lock the resistance on most mods for temp control.
Which mod are you using?

 

[robotica]

You should lock the resistance on most mods for temp control.
Which mod are you using?

Yeah lock the resistance on joyetech stuff

 

[ronzza]

I must say I'm not quite sure I can feel the difference between lock/unlock

 

[Mr Numpty]

I must say I'm not quite sure I can feel the difference between lock/unlock

TC works by making calculations from a base resistance, which has to be locked with the Cuboid. It's as simple as that, please stop advising otherwise as you have done in more than one thread now.

 

[Nukem]

I must say I'm not quite sure I can feel the difference between lock/unlock

You are giving the wrong advice the cuboid and evic vtc mini must have the resistance locked
when the coil is at room temperature.

 

[ronzza]

I apologise if its incorrect info, I'm just reading what the manual says