Problem with drop rda

[Nxthan]

Hi, so last night I was vaping away and then suddenly it came up with ohms too low, I left it and tried to sort it this morning g, but for some reason it still comes up ohms too low even with one coil in, stuck as to what to do

 

[nwhornet]

More info, coils, ohms, mod etc would make it easier to help you. One suggestion would be to try it on another mod if possible or try another attie.

 

[BULLDOG1964]

Hi it could be that one of the post screws has come lose.......

 

[Nxthan]

More info, coils, ohms, mod etc would make it easier to help you. One suggestion would be to try it on another mod if possible or try another attie.

Alien coils, 32ga, 0.45 ohms, using smok alien, tried it on smok al85 same issue, tried my kylin and that worked fine..... my drop was working fine until last night now I have this issue

 

[Nxthan]

Hi it could be that one of the post screws has come lose.......

Made sure all the screws were tight

 

[BULLDOG1964]

Made sure all the screws were tight

Are your posts tight ?......

 

[Nxthan]

Are your posts tight ?......

Nope, I literally tighten them and the keep loosening them little by little but still comes up ohms too low

 

[nwhornet]

Alien coils, 32ga, 0.45 ohms, using smok alien, tried it on smok al85 same issue, tried my kylin and that worked fine..... my drop was working fine until last night now I have this issue

Cheers pal . Bit easier to advise now. Check the 510 pin in the Drop is tight but don't overtighten. Personally I'd strip it down & clean & rebuild.

 

[BULLDOG1964]

Cheers pal . Bit easier to advise now. Check the 510 pin in the Drop is tight but don't overtighten. Personally I'd strip it down & clean & rebuild.

Thats what i would do too and start again with a new coil........

 

[Nxthan]

Cheers pal . Bit easier to advise now. Check the 510 pin in the Drop is tight but don't overtighten. Personally I'd strip it down & clean & rebuild.

Legend, just unscrewed it then screwed back in and it works cheers.... just another question, I brought the coils premade 0.45, so they should ohm out at 0.225, but when I put them in they are like 0.17, is that okay ?