Problem with drop rda

[nwhornet]

Legend, just unscrewed it then screwed back in and it works cheers.... just another question, I brought the coils premade 0.45, so they should ohm out at 0.225, but when I put them in they are like 0.17, is that okay ?

Glad that worked but would still strip down & check all the screws etc on the Drop. Regarding the coils, premades are the same as stock in that the stated ohm isn't necessarily the true ohm. If it's reading 0.17ohm on other devices/reader then should be ok but if your getting different then it needs investigating more.

 

[Nxthan]

Glad that worked but would still strip down & check all the screws etc on the Drop. Regarding the coils, premades are the same as stock in that the stated ohm isn't necessarily the true ohm. If it's reading 0.17ohm on other devices/reader then should be ok but if your getting different then it needs investigating more.

Okay mate, yeah I’m stripping it all down now, thanks for your help

 

[nwhornet]

Okay mate, yeah I’m stripping it all down now, thanks for your help

No probs. Better safe than sorry.

 

[Vapaneezer Scrooge]

Pretty sure the Drop comes with the squonk 510 pin preinstalled, did you swap it for the normal one? (without a hole in it).

If not you will be leaking juice into you 510 connector.

I have also found the Drop 510 pin to be too short on a couple of my smok mods, I fixed this by adding a tiny o-ring to lengthen the drops 'drop' height.

https://www.fasttech.com/p/2156300

 

[Nxthan]

No probs. Better safe than sorry.

Right so I stripped it all down, rebuilt, it was fine, after about 4 hits it came up ohm too low, it’s so fustrating

 

[Vapaneezer Scrooge]

see above

 

[nwhornet]

Loosen the 510 pin half a turn, as @Vapaneezer Scrooge says, it sounds like 510 issue.

 

[Nxthan]

No probs. Better safe than sorry.

see above

came installed with normal 510 pin

 

[Nxthan]

Pretty sure the Drop comes with the squonk 510 pin preinstalled, did you swap it for the normal one? (without a hole in it).

If not you will be leaking juice into you 510 connector.

I have also found the Drop 510 pin to be too short on a couple of my smok mods, I fixed this by adding a tiny o-ring to lengthen the drops 'drop' height.

https://www.fasttech.com/p/2156300

Where about a did you add the o ring ?

 

[Vapaneezer Scrooge]

Okay, try unscrewing it a turn and see if that solves the problem, if so you need a rubber seal, if it works and you are stuck finding one I can pop you 1 in the post.