Quad Coil RDA
- Thread starter Raguri
- Start date
- Status
Raguri
Nutter!
- Joined
- Mar 2, 2013
- Messages
- 8,106
It's a helios clone I have the real one now so no real use for it . I was looking to swap for something but 12 squidlits ill part with it I guess
Will have to wait until tomorrow... Just realised all my money's in my wallet! DOH!
BUT, That looks superb and ideal for my needs (Even if it's hex... 4 posts will make quad coiling as easy as pie
Gaz1983
Postman
- Joined
- Oct 2, 2012
- Messages
- 425
Will have to wait until tomorrow... Just realised all my money's in my wallet! DOH!
BUT, That looks superb and ideal for my needs (Even if it's hex... 4 posts will make quad coiling as easy as pie
Easier then pie Raguri I built it pissed up and with my eyes shut xD
Raguri
Nutter!
- Joined
- Mar 2, 2013
- Messages
- 8,106
That sounds like my kind of dripper!
Will run to the bank tomorrow and put some money into my account, Need to buy some 30amps as well for this I think!
Raguri
Nutter!
- Joined
- Mar 2, 2013
- Messages
- 8,106
Will do!
Also, just wondering - Does this only have one air hole on each side?
If so, how hard would it be to drill into all three so I had six in total (I will be running quad coils mostly, so need as much air flow as possible
)
Gaz1983
Postman
- Joined
- Oct 2, 2012
- Messages
- 425
Will do!
Also, just wondering - Does this only have one air hole on each side?
If so, how hard would it be to drill into all three so I had six in total (I will be running quad coils mostly, so need as much air flow as possible
Just one air hole. I was going to drill them my self but I kinda knew that I was going to get shot of it so just left it as is ......... Drilling shouldn't be an issue but I think you will have to be carful with the air control ring
Raguri
Nutter!
- Joined
- Mar 2, 2013
- Messages
- 8,106
I have a work bench I can use as a vice, and a hand held drill... I'm thinking that if I mark where the airholes are through the ring onto the main body, I could then drill it a lot easier. Wooo! Will run to the bank asap in the morning and send you a pm
Now this can be closed! HOORAH
Gaz1983
Postman
- Joined
- Oct 2, 2012
- Messages
- 425
I have a work bench I can use as a vice, and a hand held drill... I'm thinking that if I mark where the airholes are through the ring onto the main body, I could then drill it a lot easier. Wooo! Will run to the bank asap in the morning and send you a pm
Now this can be closed! HOORAH
Yeah that will do it defo . Ok Raguri chat to you tomorrow Mr
- Status
Similar threads
