What's new

Quick DIY Ohm / Resistance Meter

No they are the same. I'd gone the snapping off the unneeded battery terminal route, whereas Whit's is probably better and easier to solder once you've removed the spring from the centre slot.

Which do you guys think is the easiest. Planning on a guide at some point for modipedia and potv wiki
 
Mine looks harder on paper but in reality its simpler, but I would say that :P
 
basicly i did what @whitt77 has done in the diagram which is run a wire between the batt pos and neg of the middle batt slot i have not removed the spring in the middle batt slot i just put a bit of electrical tape round it. I will admit it looks a bit messy and its a tight squeeze but it works. removing the middle spring bit would give more room to put the wiring in.
 
Back
Top Bottom