Show us/me your CLOOOUDS

[Raguri]

How is cap ?
And insulator melted ?


Sent from (who cares) using Planet of the Vapes

Insulator looks perfectly fine, which is what's confused me! But whenever I go to put it on the mod it forces up the centre pin

 

[sparkyjuice]

Insulator looks perfectly fine, which is what's confused me! But whenever I go to put it on the mod it forces up the centre pin

You're supposed to back off the top cap delrin to just touch atty then have loose batt the switch launches the batt up


Sent from (who cares) using Planet of the Vapes

 

[Raguri]

You're supposed to back off the top cap delrin to just touch atty then have loose batt the switch launches the batt up


Sent from (who cares) using Planet of the Vapes

I did that, also tried on the Ray, same thing

 

[Mr.Motivapr]

Cloud test.: http://youtu.be/BubWd8N3gyM

sparkyjuice, mephisto is poorly already. Same issue as before, centre post is lifting.up! :'( didn't even rag it!

And MrDeseVaper, this is what I call calm.... hahah

Looking good rags

 

[sparkyjuice]

Push down the centre pin and tighten up 510 screw all I can suggest


Sent from (who cares) using Planet of the Vapes

 

[Raguri]

Push down the centre pin and tighten up 510 screw all I can suggest


Sent from (who cares) using Planet of the Vapes

Will give it another look at tomorrow

 

[Gaz1983]

https://www.youtube.com/watch?v=hUdFBDqZakk&feature=youtu.be

Killed it !! Best yet


Sent from my iPhone using Planet of the Vapes

 

[xibxang]

28 gauge twisted dual coils @ 0.5ohm. I'm quite pleased, although that's not saying much.

 

[Chegs]

A cloud I just managed to catch on camera just before I dropped the tablet. Every try, the sodding tablet leaps out my grasp

posted by an unauthorised idiot

 

[3dj]

Insulator looks perfectly fine, which is what's confused me! But whenever I go to put it on the mod it forces up the centre pin

When my centre pin fell out. due to the mod contact pin pushing it up. I araldited it back in, screwed the positive pin up tight. It works like a dream now, but have to use button tops to take up the gap that screwing the positive screw has caused. Luckily I have some 30amp purple efest button tops.

I think they were just shit clones mate. Got one coming from FT. See if they are any better.