Sigelei #19 contact problem

[Banu]

Some of my Vivi Novas and Boge cartomisers are not making contact on my Sigelei.

They work fine on my Vamo.

Is there a way of 'dropping' the centre pin (don't know the correct name) on the Nova and Boge ?

I have tried pushing up the contact on the Sigelei, but its at the max.

Any help gratefully appreciated.

 

[ZT]

Hi Banu,

Im not sure what the sigelei is like .. some Mech mods allow you to adjust the center pin on the mod themselves .. does the 19 allow this ?

Cheers

 

[KulrMeStoopid]

the center bit on the vivi's and the boge should wiggle enough to make contact, but if you over tighten them it will eventually break contact again....can you pop up some pics of the 19's connection?

 

[whit77]

The sigelei 19's center pin is adjustable, by a fair amount too

 

[Banu]

The centre pin on the Sigelei is pushed in as far as it will go, and it works fine on some of the Novas.

I noticed that the centrepin on the Boge and Novas that DON'T make contact is flush with the outer ring. I tried turning with a screwdriver but that doesn't work.

Is it possible to pull out somehow.

 

[AndyC1971]

Personally I would use a ego to 510 adapter. It will work then

 

[Banu]

Ahhhh ok. That's till doesn't explain why some work and some don't. Very confused.

 

[KulrMeStoopid]

Ahhhh ok. That's till doesn't explain why some work and some don't. Very confused.

different makes I bet...they might look the same, but I bet there is a subtle difference here or there!

 

[whit77]

The centre pin on the Sigelei is pushed in as far as it will go, and it works fine on some of the Novas.

Really! I find that strange, I find it too long for most attys and need to adjust it out, when you say "pushed" you are turning it? as its threaded

 

[mattnap21]

You have probably tried this already but here goes
If you un-screw the white magnet holder first. Then screw the atty down as far as it will go, then screw the white contact back up to it
If that make sense