Smok X cube ultra and ohm

[AdriaNocenzi]

Hi all

I starting to pay more attention when I make coil as I'm using the squeeze on daily basis, I use the steam web site and I pretty sure I done 8 wraps is 316l 28ga which should be 0.5 ohm, but when I put on the smok say 0.66 ohm so now I wonder maybe the smok is not accurate?

 

[AdriaNocenzi]

Pic

 

[mick brown]

Did you clear the current reading before you put your new atty on it ? Press the fire button on the smok with nothing screwed on so it says no atomizer or something similar, then screw your new tank on.

 

[AdriaNocenzi]

Did you clear the current reading before you put your new atty on it ? Press the fire button on the smok with nothing screwed on so it says no atomizer or something similar, then screw your new tank on.

Yes I did, unfortunately I don't have any other mod or coil tester to double check

 

[mick brown]

Are you sure you entered the right figures.

 

[AdriaNocenzi]

My is a dual coil at 3,5 mm internal size

 

[mick brown]

My is a dual coil at 3,5 mm internal size

My bad. You'd need about 12 wraps for 0.66. If you haven't got a bad connection then I don't know mate. I know stainless can rise and fall in ohms as it heats up and cools that's why in tc mode you need to lock the resistance at room temperature but I wouldn't have thought it would vary that much !

 

[AdriaNocenzi]

Thank you for your help anyway, but one question 12 wraps per coil or 12 in total ? Because if is in total I got 16 as 8 each

 

[AdriaNocenzi]

May be I don't know I to count.

 

[mick brown]

Thank you for your help anyway, but one question 12 wraps per coil or 12 in total ? Because if is in total I got 16 as 8 each

12 per coil for 0.66 I think it was.