Tin Mod headache. Please help/advise

[EthelKing]

@eshelby_dunn - you are putting about 7 volts through the circuit! Not a good idea. You need to either power it by a single battery at 3.7V or wire the batteries in parallel to keep the voltage the same but double the capacity. Or stick in a VV board and meter and make it a VV mod.

Check out this link for more info:

http://batteryuniversity.com/learn/article/serial_and_parallel_battery_configurations

Also, make sure you insulate all of your joints to make sure they don't short against the body of the tin.

Hope this helps, and keep us posted of how you get on.

 

[sparkyjuice]

Not sure if hitting an evod coil with 7.5v in an unregulated mod is good idea try a parallel batt config


Sent from (who cares) using Planet of the Vapes

 

[doobedoobedo]

+1 for getting everything insulated.

 

[eshelby_dunn]

Dexter, sparkyjuice Thank you both very much for all your time and help.

 

[EthelKing]

@Dexter, @sparkyjuice Thank you both very much for all your time and help.

You are more than welcome! I'm no expert, but if I can help - feel free to shout out

 

[sparkyjuice]

Welcome (if I was any help)