D
Deleted member 58360
Guest
Are those blobs joins?
Could they be nr-r-nr wire?
Could they be nr-r-nr wire?
Bloody hell, I hadn't even noticed that
Just zoomed in on a photo of the coils, 2 blobs on each.
I also emailed Oumier 2 days ago about the coil spec but got no reply.
View attachment 207105
Are those blobs joins?
Could they be nr-r-nr wire?
Joins?! that's mad! do you think they just made one huge coil and got slave labour to snip and add the legs?
No, as mentioned by pdg, it'll be a combination of resistance wire and non-resistance wire. It's not common but it is out there. I've used them on a couple of occasions before when they were supplied with a device I purchased but I've never seen them joined as cleanly as this before where it's almost un-noticeable. On the coils I've used previously you could very clearly see there were two different wires making up the the legs and then the coil itself. Why Oumier have gone down this route I have absolutely no idea. They haven't responded to my emails yet but I saw a phone number on their website so I may well ring them after Christmas if they haven't replied by then.Joins?! that's mad! do you think they just made one huge coil and got slave labour to snip and add the legs?
My 3mm Ni80 28g coil is about the same draw wise, I thought it wasn't too bad until I picked up the Glaz straight after, I've resigned to the fact it's a good flavour loose draw MTL RTA, first time an Oumier product hasn't delivered fully for me.