Zenith coils burning out instantly!

[Miss Pepper]

The way I prime my coils (completely different set up than you have, but it's what I've done for years)

(1)
A few drops of juice in the holes
A drop of juice down the middle
A few drops of juice in the holes
Stick the tank back together
Close the airholes on the tank
Take several drags, DO NOT hit the fire button!!
Open the airholes back up

(2)
Turn the watts down a bit
Take a small drag
If it's ok, turn the watts up a bit
Take a small drag
If it's ok, turn the watts up a bit
Repeat until I'm at the watts I normally vape at

(3)
If it's not ok, close the airholes off again
Take drags, but DO NOT hit the fire button

(4)
Repeat steps 2 and 3 as appropriate

Supermarkets sell eliquid, branded too.
Garages and local shops selling cigarettes do too. You won't be stuck without a vape, you just need to buy the right pg/VG ratio for your set up.

 

[MissPopadop]

I had 3 or 4 Zenith 1.2 coils in a row that almost made me gave up on the Innokin Zlide. I'm MTL and don't go below 1.0 ohm but I now prime either 1.2 or 1.6 coils by dripping into each hole and into the top and then leave to soak up overnight.

I now use the Zlide exclusively with Manabush 50/50 and, although I've tried other combinations and brands, this one gives me the best vape.

 

[Adrian muza]

Been experimenting with the zenith coils for a while now...i can tell you that i had succes with the 3d mesh 0.48 and the 1.6 z coil....thing i found out is if you have a mod with vpc I use this settings : 0.48 - 13 13 14 13 12
And 10 10 11 10 9 for the 1.6
Both of them last me 2-3 weeks,lose some flavour after 1 week but perfectly usable,no burning.cheers