3d dripper.

[Crackerman]

Got one of these , stripped it down and gave it a good clean, put it back together and now the posts are not level ,also the screw on the positive post isn't screwing all the way down. Any help would be grateful.

Sent from my SM-N9005 using Planet of the Vapes mobile app

 

[clint]

There are 2 tiny washers missing from the positive post which are used for trapping your wire in between.

As for it not being level, are the posts sitting on top of the fill hole?

 

[Crackerman]

clint thanks for the reply the posts are screwed down as far as they go with the fill hole in the centre. As for the positive post therewas no little washers on it when i got it? Any idea where to get these?

Sent from my SM-N9005 using Planet of the Vapes mobile app

 

[clint]

If I remember, I had to unscrew the negative screws out slightly to screw in the terminal section, maybe that'll help with getting them level. As for the washers, I have some. They look ever so slightly wider than the original ones but they should work fine. I'll send you some if you want, just send a pm with your address.

 

[Crackerman]

Will give that a try mate. Thanks for the offer will pm you. Cheers.

Sent from my SM-N9005 using Planet of the Vapes mobile app

 

[clint]

Crackerman did you get this sorted?

 

[Crackerman]

clint all sorted had the spacers on the negative screws the wrong way round!! Great little atty ideal for work, saves dripping while driving. Lol.

Sent from my SM-N9005 using Planet of the Vapes mobile app

 

[clint]

Glad you got it sorted. I quite like mine too. Wasn't sure when I first got it but after taking it all apart to wash it, I was pleasantly surprised to see how well made it is. Doesn't look like much can go wrong with it either.