Advice on AROMAMIZER RDTA build

[mrcheeks78]

I recently picked up the aromamizer RDTA with velocity deck and was hoping for some advice on what would be the best build to roll with. Really a bit of a novice at building so was thinking simple dual set up would be easiest, although not sure what thickness of wire to use? I currently have 24-28AWG. I had a look on steam engine and to get around 0.3ohms it would require 7/8 [email protected] with the 24AWG, which may struggle to fit in the tank. So thinking the 28AWG would be better?
Any advice would be greatly appreciated .


Thanks

 

[Beastie]

https://www.planetofthevapes.co.uk/forums/index.php?threads/84288/ this thread kind of goes through all of it. Personally I've been rocking 26 or 24 gauge kanthal, spaced vertical coils ohming out roughly 0.4 with the cotton tails just resting on the deck floor.

 

[Unclebilbo]

I've got 3mm claptons in one of mine so with your 24g 3mm coils will be no problem and allow a bit more wicking.

 

[mrcheeks78]

Thanks guys I'll give it a go

 

[ryan_j]

https://www.planetofthevapes.co.uk/forums/index.php?threads/84288/ this thread kind of goes through all of it. Personally I've been rocking 26 or 24 gauge kanthal, spaced vertical coils ohming out roughly 0.4 with the cotton tails just resting on the deck floor.

Same!

 

[r4nd0m]

I use 24awg titanium wire from sweet spot - 7 wraps dual vertical could @0.16ohm I think the tank is perfectly made for vertical coils