DNA Go board mod

[Mr Ripple]

Are you in temp or wattage mode?

Ohms Too High Error? Here’s How to Fix It

What does “Ohms Too High” mean on a vape, and how do you fix it? Get the answer in this straightforward guide.

www.google.com

 

[GoWo]

atty tested in replay & power modes on 75c, I'm gonna put this to one side until Monday , thanks for your help @Mr Ripple

 

[ripe_plantain]

'Ohms too high' would suggest your min and max resistance settings in the atomizer profile settings need adjusting. SS will raise it about 20% from what's read as cold.

 

[GoWo]

'Ohms too high' would suggest your min and max resistance settings in the atomizer profile settings need adjusting. SS will raise it about 20% from what's read as cold.

Thanks for replying, I did notice the default settings for profile 1 was wide open, like between .1 to 2ohm, which I thought should work with most builds, then I did try a few more conservative settings based on the coils for both attys I built .... still too high .

 

[mattc1]

I would say those ego boards work very well with 0.5ohm. Soyou have that bit right. Im sure you will sort it.

 

[todd]

I would say those ego boards work very well with 0.5ohm. Soyou have that bit right. Im sure you will sort it.

Totally agree, building on the go board is totally different from what you would normally build. Fries your brain a little bit but aim for the 0.5 area as Matt suggested

 

[GoWo]

Cheers @mattc1 & @todd , I have messaged the guru @ Stealthvape, see if Rob can shed some light

 

[GoWo]

Had some good suggestions from Rob @ Stealthvape after he looked over the pics , I'm away on hols so I'll have a look at it again when I'm back.
73mm x 45mm x 25mm