Envy 22 TC issue

[used_gear]

Has anyone notice that envy wouldn't keep the original resistance?
My first 3 - 5 draws are perfect and the no matter what but protection kicks in for half a sec then sec and grows... and no matter how long I leave it to cool down... only help if I re select TC mode again...
No it's not wiking.
Running SUBTANK MINI new RBA with NI200 at .15 ohm.
Any thought?
P.S. same atty on IPV2S runs perfectly fine but I want to use it stelth in envy...
HELP!

 

[Tubbyengineer]

Has anyone notice that envy wouldn't keep the original resistance?
My first 3 - 5 draws are perfect and the no matter what but protection kicks in for half a sec then sec and grows... and no matter how long I leave it to cool down... only help if I re select TC mode again...
No it's not wiking.
Running SUBTANK MINI new RBA with NI200 at .15 ohm.
Any thought?
P.S. same atty on IPV2S runs perfectly fine but I want to use it stelth in envy...
HELP!

It's got to be a connection issue with the 510 on the envy...

 

[used_gear]

It's got to be a connection issue with the 510 on the envy...

Interesting... but it sits tight in...
Any other thoughts.

 

[danb]

Has anyone notice that envy wouldn't keep the original resistance?

So after it cools but the problem persists, what resistance does the mod read - higher than before or the same as before?

 

[used_gear]

So after it cools but the problem persists, what resistance does the mod read - higher than before or the same as before?

Normal. 0.15

 

[danb]

Normal. 0.15

Could be an issue with resistance locking maybe? I'm not familiar with the mod, so I can't really offer anything else... If the tank works well on a different mod, that points to the envy as the problem (as you say).

 

[used_gear]

Could be an issue with resistance locking maybe? I'm not familiar with the mod, so I can't really offer anything else... If the tank works well on a different mod, that points to the envy as the problem (as you say).

My understanding is that envy locks resistance when you select TC mode but it doesn't keep it locked...
Thanks anyway

 

[used_gear]

Are there any more envy 22 users out there?

 

[Tubbyengineer]

Interesting... but it sits tight in...
Any other thoughts.

It's usually the centre pin not connecting quite well enough, is it sprung?