First aga-t coil

[Lord Grim]

The only way to get round a new coil each time that I can think of is leave a little extra wire on it when you first build it, so it is possible to get it back in place relatively easily. Just make sure that you are careful where you leave your positive tail and that you don't short anything out

 

[Purplefowler]

I just use a needle top bottle filled with water and flush it out through a wick hole then force air through. It's not the most thorough clean but it does the job when I can't be arsed to strip it down. I would imagine it would work just as well on the T as it does on the S.

 

[jimsie33]

I just use a needle top bottle filled with water and flush it out through a wick hole then force air through. It's not the most thorough clean but it does the job when I can't be arsed to strip it down. I would imagine it would work just as well on the T as it does on the S.

Sounds like a viable option thanks Purplefowler will try this first, if strip down time

 

[jimsie33]

Right, stripped down leaving wick in just disconnected positive pole. Been vaping on and off all afternoon refilled with WavesOfVapour going bananas. Just sat down and noticed a few vertical cracks in the tank Where can I get a pyrex tank?

 

[jimsie33]

Stainless tank

 

[lazydog]

www.safercigs.co.uk
and
http://www.ivapour-elixir.co.uk/parts/rebuildable-atomisers/aga-t-glass-tube.html

 

[jimsie33]

Cheers lazydog, will get one on order tomorrow just some stainless mesh to get now

 

[jimsie33]

Just ordered a glass tank and a couple of pre cut stainless wicks! Roll on Monday

 

[VapingKing]

RE: cleaning, Is it bad that I just run mine under the tap and give it a good shaking?

 

[jimsie33]

Have cleaned mine out with a nipple top bottle but I think stripping down is more thorough. Pain in the arse though. Looking forward to getting some mesh Monday as getting the silica wicks back in when they're wet is a nightmare.