Hey guys need some help here, got my kayfun lite clone today from focalecig (only ordered it on 17th so very fast) Just built my first ever micro coil, comes in around 1.6/7 ohm. Just wondering what voltage would be safe on an mvp2?
Just start low & see how the vape is. Increase until you get a good vape & if it goes over, back it down a bit. For the record, i have a microcoil in an rda @ about 0.9ohm on my mpv & i'm running the device at 11 watts.
Low resistance coil = lower wattage required
Higher reisistance coil = higher wattage vaporizer on anything below 1.3 ohm changing volts or watts will do jack shit on an mvp anything below 1ohm is not recommended on these devices and regardles of what you have it set to it will regulate it to give only what is required. Not having a dig just sharing the love
damn the vapour is pouring out of it, however the taste is absolutely foul. Hard to explain what it tastes like. Not sure if its the cotton or the actual eliquid. Any way to get the juice out of the kayfun without spilling or leaking?
Its 100% pure baby cotton wool from tesco's that i had laying about in the house. Emptied the GY4 from it rewicked it with some strawberry ice cream (again grizwalds) and that was fine no awful taste so i think either the gy4 had gone bad or its one of those flavours that taste horrible, cant really say as it was the first time ive tried it out. Gone in the bin though.