Odis atty haldaly goon lp

[Tray Virus]

Just ordered these 3 tanks and a wraith squonk mod from fasttech.
Never built coils before as I always used the coils rta come with in standard packaging.
With a 75watt mod I'll be needing to vape at lower wattages to get better flavour with these devices so I'm thinking I'll be needing 28g kanthel wire with coil width at 2.5mm using 6 wraps.
Is this just fine tuning experimenting when wrapping making your own coils trying to guess the ohms you want to vape at? Ideally I'm thinking 0.05 ohm would be ideal with the mod and the rda at about 45/50 watts. 28g kanthel would be sufficient?

 

[gazlynn]

http://www.steam-engine.org/ is your friend m8.

I hope you mean .5 and not 0.05 ohms?

I would spend a little time educating yourself on steam engine, different wire resistances and ohms law.

cheers

Gaz

 

[Dogmeat]

Go here http://www.stealthvape.co.uk/wire/nichrome-80-spools-reels, buy a spool of 0.4mm, 5 or 6 wraps at 2.5mm will see you right for single coil.
As stated above use the steam engine app for your tinkering to be safe.

 

[EmbraSewerRat]

Unfortunately Stealthvape are out of useful gauge flattened wire the now - ahem.... cough, cough...

Now, please don't kill me for posting links to the other company!!

http://www.wireandstuff.co.uk/produ...-Made-Flat----10-Metre-Spool-468.html#SID=125
http://www.wireandstuff.co.uk/produ...und-Wire-Made-Flat----10-Metre-Spool-474.html

Either of these two should do you. The Ni80 is lower resistance then the Kanthal and 'd probably go with that.
Do read up on using Nichrome/ni80 tho' if you've no used it before and for damned sure go put some figures in the Steam Engine coil calculator as posted above!

 

[city461]

Now, please don't kill me for posting links to the other company!!

Falls off chair.....

 

[Huggett]

Falls off chair.....

Ditto. Just spat my orange out

 

[Tray Virus]

Very helpful guys thank you very much, I already got steam engine app.
Not researched nichrome wire as yet but can that be used on vw set up or just temp control only?
I can research later but at work and time is limited at the moment.

 

[Huggett]

Very helpful guys thank you very much, I already got steam engine app.
Not researched nichrome wire as yet but can that be used on vw set up or just temp control only?
I can research later but at work and time is limited at the moment.

I'm not upto date on TC, but Nichrome was used before temp control existed

Mainly by mech users back then, due to its lower resistance and quicker ramp up than Kanthal.

 

[gazlynn]

I use Nichrome in Power / wattage mode.

cheers

Gaz

 

[eyeball kid]

Nichrome can be handy on regulated if you want.some serious surface area per ohm. But it is still my go to on a mech squonk.