Sgt_Rock68
Initiate
- Joined
- Jan 26, 2017
- Messages
- 11
I'm slowly getting better with things, but..
I've just switched tanks from Smok rba to an Augvape Merlin.
Made a nice single coil(I'm still a novice, but improving), not dual.
I'm getting a lovely vape at 30W, but ohms are a good bit higher.
My readings on R200 with 30W are 5.1 volts and 0.85 ohms.
Are these fairly typical readings, i.e. Safe, normal?
With approx half the wattage, I'm getting a similar vape as I was with the Smok(using 50'ish watts) with dual coils
Seems to good to be true!
(Using Kanthal A1 Clapton wire 26ga btw)
I've just switched tanks from Smok rba to an Augvape Merlin.
Made a nice single coil(I'm still a novice, but improving), not dual.
I'm getting a lovely vape at 30W, but ohms are a good bit higher.
My readings on R200 with 30W are 5.1 volts and 0.85 ohms.
Are these fairly typical readings, i.e. Safe, normal?
With approx half the wattage, I'm getting a similar vape as I was with the Smok(using 50'ish watts) with dual coils
Seems to good to be true!
(Using Kanthal A1 Clapton wire 26ga btw)