Thoughts On The Sxmini Puremax

[Netvaper]

There seems to be a newer pod released to rectify the reported leaking. I guess there will be some of the older pods still being sold.
Some sites state that it is the new pods they are selling.

I'm pretty sure the ones I have are the new ones as they have a front slide up door as opposed to side fill.

 

[DMAN]

I'm pretty sure the ones I have are the new ones as they have a front slide up door as opposed to side fill.

Thats not good then. Did you fill it and put it aside, as the advice is to vape it after refilling to recreate the vacuum?

 

[Netvaper]

Thats not good then. Did you fill it and put it aside, as the advice is to vape it after refilling to recreate the vacuum?

Filled it up when I got it to try and haven't refilled it, its just below half full. I'm glad I never leave pods in it as it's a deep one so would be a real pita to mop up spillage.

 

[DMAN]

Filled it up when I got it to try and haven't refilled it, its just below half full.

Hopefully you just have a dodgy pod. I've 2 on the go, but they haven't been left unused for a day and i haven't had any leaks.

 

[DMAN]

Maybe leaving it outside the mod could cause it?

 

[Netvaper]

Hopefully you just have a dodgy pod. I've 2 on the go, but they haven't been left unused for a day and i haven't had any leaks.

I hope so but I don't use it every day as I bought it for out and about use only.

Maybe leaving it outside the mod could cause it?

Can't think why it would but I never leave a pod in a mod when not in use or indeed a tank on one if not going to vape it for a bit.

 

[DMAN]

I hope so but I don't use it every day as I bought it for out and about use only.



Can't think why it would but I never leave a pod in a mod when not in use or indeed a tank on one if not going to vape it for a bit.

I was just thinking that it is a tight fit, and maybe taking it out removes the vacuum?

 

[Netvaper]

I was just thinking that it is a tight fit, and maybe taking it out removes the vacuum?

The pod base has a couple of holes which I assume is where the air gets in from the hole next to the airflow control but it sits proud of the base so I wouldn't think it's that. I hope it's just a blip and I haven't got my third leaking pod kit!

 

[DMAN]

The pod base has a couple of holes which I assume is where the air gets in from the hole next to the airflow control but it sits proud of the base so I wouldn't think it's that. I hope it's just a blip and I haven't got my third leaking pod.

Stick it back in the device, take a few puffs and leave it overnight to see what happens?

 

[Netvaper]

Stick it back in the device, take a few puffs and leave it overnight to see what happens?

I've taken quite a few draws on it outside and inside the mod and it has cleared the gurgling and it seems ok now but I wouldn't risk leaving it overnight. I'll see how it goes and report back if it happens again.