mosteeze
Postman
- Joined
- Sep 12, 2015
- Messages
- 108
Hi guys, so I'm still kinda new to building on Gennies, but I'm learning slowly. I've tried a couple of different builds (normal rolled 300/mesh inside a mesh etc.) But I'm focusing on a long 200 mesh inside a short 400 mesh at the minute. The size accuracy is pretty good on the mesh (18mmx50mm & 8mmx25mm) and I'm sure I'm wrapping the coils good too, enough for an even glow and good ohm reading on SS 26ga anyway.
The problem is, I can't take one small hit off the Genny without liquid coming up through the mesh and absolutely drowning the coil and seeping out the airflow hole. I've tried numerous different builds and methods to try and stop it, but it seems nothing will stop the liquid from swimming up and wanting to be consumed (no shit if I took 2 draws off this thing with closed airflow I'd be drinking Vanilla Custard.) Hopefully some of you Genny veterans might see this and throw some info my way but I look forward to receiving any advice at all. Thanks a bunch!
(Forgot to say, yes this is a clone!)
The problem is, I can't take one small hit off the Genny without liquid coming up through the mesh and absolutely drowning the coil and seeping out the airflow hole. I've tried numerous different builds and methods to try and stop it, but it seems nothing will stop the liquid from swimming up and wanting to be consumed (no shit if I took 2 draws off this thing with closed airflow I'd be drinking Vanilla Custard.) Hopefully some of you Genny veterans might see this and throw some info my way but I look forward to receiving any advice at all. Thanks a bunch!
(Forgot to say, yes this is a clone!)
Last edited: