bellyman
Veteran
- Joined
- Jan 31, 2015
- Messages
- 7,701
Where are you geting the clones from eg FT
Im gonna try one never had a clone before so interested to try.
Choose a decent cloner like SXK or YFTK and it should be ok.
Where are you geting the clones from eg FT
Im gonna try one never had a clone before so interested to try.
Did you try one of the original grub screws? I reckon I was lucky with my no-name clone. It’s been perfect. So much so I didn’t bother buying an original which was my intention if I liked the cloneLets not even go into the kflite's nasty habit of dribbling through it's centre-pin adjuster either, finally resolved that particular issue with a couple of wraps of PTFE tape.
Yes I do Full airflow is my bag on this one.Yep I like mine a lot. I find it needs a slightly airier draw than I like to get the best flavour from it though.
Don’t tell anyone but I’ve had the odd fully open go too. Rather nice.Yes I do Full airflow is my bag on this one.
Come to think of it I seem to remember all the troubles you’ve had now. Sorry my memory is awful@Discomatt I've tried original plastic ones, original replacement centre-pin, supplied steel grub screws and new steel longer grub screws, still leaks. That's why I dug round the garage and found the PTFE, issue solved.
The OP is asking about high end gear, not 5$ shit from fasttech....just an observation
@Mike Williams defo try the reaper it is very good. Im gonna try the clone kayfun and why not. I have a few atties not many but I find I only use a few. These cover my interest.I’ve vaped using all kinds of mods and RDA builds for the last 7 years, but high end RTA’s are all new to me! Thanks for your advice!