9atty5tip desk tidy

[chainmaker]

Well folks... this is the original that started me tinkering with these designs...Thanks Dazlarsen!

It is a simple 9 x 510 atty & 5 drip tip desk tidy.





Oh! the powers that be have kindly given me a Mod Maker doofer so i can legitimately pass these on via the modders classies. Yay!

Stay safe, stay well, dream well & see you vapefest!

Chainy

 

[Blossom]

chainmaker, are you bringing any with you?? I know, I'm hassling, but I really need on of these, the dogs keep knocking the coffee table and everything falls over!! If not, I'll keep an eye on the classies! Hope to say hello to you tomorrow.

 

[chainmaker]

Blossom yes i will be bringing three bits with me (not planning on bringing the round one as i need to stress test it due to its construction).

Have also posted in the modders classies with some details.

 

[chainmaker]

well might run up a badge in a bit. not sure what i`ll be wearing yet but i`m sure my hair will be doing it's mad professor afro than having gotten up at stupid o'clock.

So.. look out for a wierdy beardy with mad hair (probably in black shorts, black t-shirt etc). Wait.. that describes at least two people i know going... gah!

 

[ScottChensoda]

Can you let me know the hole diameters so I can work out what will fit and what won t?

 

[whit77]

Can you let me know the hole diameters so I can work out what will fit and what won t?

Plenty big enough for you're tackle lad

 

[chainmaker]

Arg.... classies post is now up as far as i can tell. having a muppetry day today

 

[chainmaker]

@ScottChensoda

the smallest holes are for 510 atties and are a little larger than requires. (tested with an RSST, Davide, Igo-w & FT dripper & iClear30)

medium holes (usually along front edges) are for drip tips and should be slightly larger than required. Fit will be dependant on your tips as there seems to be a good deal of difference in tip/o-rings tolerances out there (see reviewers trying to cram diff tips into diff devices with no luck).

largest holes are to hold ego/clearo's etc (tested with iClear16 and mini protank (little loose that one)

This why i was prototyping them to try and ensure that the vast majority of stuff fits.

 

[ScottChensoda]

Thanks very much for the info CM.

 

[ScottChensoda]

Plenty big enough for you're tackle lad

You've been spying again. It's a wonder you didn't make any references to a pin prick