A tip that could save your mod

[vapervince]

When I used dwarf atties you could almost guarantee that by the end of the day or if left overnight there would be a little juice or condensation below the chamber, quite often it would be sucked between the atty and the mod, to guard against that I took a small o ring that was meant to fit a 510 drip tip and put it onto the 510 connector, it was just the right size to hold in place and it is very efficient at keeping any unwanted spillage out of the recess on the mod.

 

[DMAN]

Buy decent atties and you wont get leakage.

 

[Crispycritters]

Buy decent atties and you wont get leakage.

But you will get condensation - and even with a 'good' atty it is only as good as the users wick fu, and everybody screws up occasionally.

 

[Joe 90]

I find closing the airflow on the atomiser when left overnight helps also

 

[vapervince]

It also gives a bit of adjustment without any looseness when you`re using drippers with diametrically opposed air vents so you dont get juice down your shirt when you take a hit.