Annoying- RDA positive post turning as I tighten it?

[conanthewarrior]

Hi everyone, I have a bit of an annoying problem with my Vector RDA.

I just rebuilt it for my kindred V2 mech mod, and as I tightened the centre positive post to the wire of the coil, it started moving in the direction I was tightening the screw!

It only moved say 1/8th of a turn, so I could twist it back with a pair of pliers. The positive screw at the bottom of the 510 is fully tightened so it should not be loose or able to move.

Does anyone know of a fix for this, or will I have to put up with it and just turn the centre post back in place each time I rebuild this RDA?

 

[LordOdin]

Was gonna mention the Airflow Pin/ 510 Pin but you say that's already tight. I would remove the Pin and make sure everything is seated right then put it back in and tighten it.

 

[conanthewarrior]

Was gonna mention the Airflow Pin/ 510 Pin but you say that's already tight. I would remove the Pin and make sure everything is seated right then put it back in and tighten it.

Ok, I will try and take it apart and put it back together again.

I wondered though, if the positive can spin could this potentially be an insulator issue and it is not holding the positive tight enough? As if it could be an insulator issue I would retire the RDA, especially from mech mod use.

 

[LordOdin]

Ok, I will try and take it apart and put it back together again.

I wondered though, if the positive can spin could this potentially be an insulator issue and it is not holding the positive tight enough? As if it could be an insulator issue I would retire the RDA, especially from mech mod use.

That was mt thought, maybe the insulator wasn't seated right, i have had that happen before.