Well I am very pleased to report that my first attempt with the Ehpro tank resulted in none of the gurgling and flooding I experienced with the Ammit.
Initially I used the clapton 1ohm coil that came with the tank and the only issue was a some popping and spitting which was mostly cured by using a little less wick. Now I'm using a 1.6ohm coil it's better still, although I am still getting some spitting if I use more than 11W which doesn't produce quite enough vapour; any higher and I can hear it plus taste juice in the back of my throat.
The coil I made is a 2.5mm dia 1.6ohm on 28/29ga kanthal and I like to use the tightest air restriction on this tank. I'm not sure what changes to the coil setup I should make to reduce spitting and increase vapour production, any suggestions would be welcome.
Maybe it's the wick that's the issue, I'm currently using the wick pad that came with the tank. I need to order some soon so again any suggestions as to what type works best with this tank/setup would be welcome.
Cheers!
I'm using 29awg - 6 wraps tightly (clockwise usually) wound tightly 2.5mm = about 1.35 Ohms to 1.4 Ohms
The coil is WOUND tightly to the bar to get similar consistent coils, but coil is still SPACED - in case you are confused
(for some reason the coils come out about 0.05 to 0.10 Ohms lower in True than other tanks - better conduction ???)
Anyway you should not need any more than 11w - but pay attention to the volts
on my coils I rarely need to go above 3.7v - often 3.6v to 3.65v or running at 9.5W to 10W
(depends on mod)
If I go much above 3.65v on Galaxies MTL RTA it spits like a banshee on first draw from cold
Position the coil around 2mm from air jet nozzle on deck - but is a bit tricky to see as it rises in middle
Position the coil high enough to clear risk of saturated wick touching the air block
but low enough to ensure flavour - you will suss it as well as as near as possible the coil is level and centred etc...
( if you have ultra OCD like moi you can end up fucking about with coil positioning more than the wicking
)
Once sussed with coil created & positioned as close to perfection as possible with decent cotton
then you will not need so much Amps or Volts to release the full flavour (trust me)
You are nearly there but just atm you are bumping up the electricity "juice" to obtain the slightly missing flavour from e-juice
Well that is what it sounds like to me
Oh and if you want more vapour - open up the air hole to allow more air into the tank
then you get more vapour, or smaller air hole for tighter draw with less vapour
if you want more vapour - select the largest hole, though I like moderate draw/vapour so use 2nd smallest
