I'm scared. I've created a monster

[sparkyjuice]

Good news Seedy


Sent from (who cares) using Planet of the Vapes

 

[RicModMaker]

All fixed up and not scared of venting batteries anymore. However, I need a serious dripper. I did a dual coil kraken today with undersized ekowool and cotton so it wicked super fast. Tip it and loads of bubbles. This bad boy ate the kraken up for breakfast. 0.8ohm dual coil lights up so fast, its stupid. I could do with a couple of extra coils to slow it down so I need a cheap dripper to play with that's big, has post holes and preferably adjustable airflow up to 3mm x 4 holes. Any suggestions?

Sent from somewhere just south on our nations capital.

 

[Chegs]

Chuck a w3 on it, quad coiled with some 0.5 mm wire should see you vaporising the juice before it manages to dribble out the air holes over your fingers.


I did a bit of re researching and when you asked earlier about a smaller potentiometer with a Raptor, the answer is a YES

Sent from my SM-T210 using Planet of the Vapes mobile app

 

[RicModMaker]

Chuck a w3 on it, quad coiled with some 0.5 mm wire should see you vaporising the juice before it manages to dribble out the air holes over your fingers.


I did a bit of re researching and when you asked earlier about a smaller potentiometer with a Raptor, the answer is a YES

Sent from my SM-T210 using Planet of the Vapes mobile app

Thanks Chegs. I think I may as well add to my igo collection.

Sent from somewhere just south on our nations capital.

 

[Dennis]

16a I do believe.

Sent from somewhere just south on our nations capital.

Freshly charged batteries will produce 8.2V.
With a 0.4ohm atty you'll draw 20.5A at 168W!
Better upgrade your switch.
What's the max current for those wires?
Annnd...isn't stacking unprotected batts on a mech dodgy?

 

[RicModMaker]

Freshly charged batteries will produce 8.2V.
With a 0.4ohm atty you'll draw 20.5A at 168W!
Better upgrade your switch.
What's the max current for those wires?
Annnd...isn't stacking unprotected batts on a mech dodgy?

I never said it was safe! I know it isnt. The switch is meant to be 25a so as I'll not be getting much below 1 ohm, it'll be fine. The wires are 1.5 and 2.5 solid copper from twin core and earth lighting and mains cable. I am still slightly scared though as this thing hits so hard its unusable at the moment with a .8 ohm coil. I need a quad coil in this beast but need to do some big coils to keep the ohms high enough.

Sent from somewhere just south on our nations capital.

 

[Dennis]

LOL. OK.
And your batts? Can't go lower than 8.2 ohms without drawing more than 10A. Are they up for that?
They're connected in series so they both get the same amps.
Power to you, mate and be safe.

 

[RicModMaker]

LOL. OK.
And your batts? Can't go lower than 8.2 ohms without drawing more than 10A. Are they up for that?
They're connected in series so they both get the same amps.
Power to you, mate and be safe.

30a sonys. I'll try :-)

Sent from somewhere just south on our nations capital.

 

[Dennis]

30a sonys. I'll try :-)

Sent from somewhere just south on our nations capital.

Considering your switch's 25A limit, you're safe up to 205W!

 

[RicModMaker]

I'm gonna need some big coils!