Kayfun for MVP v2 coiling

[scrumpox]

1.2 ohms. The idea behind the twisting of the wire is that there is a greater surface area of wire available to vapourise the juice for a similar (ish) resistance to something around 3 wire gauges thicker (roughly).

You can do it by hand with a pin vice, but any battery drill will do very nicely.

Sent by Harbinger from the edge of the Apocalypse...

When he had the 3 wires together Rip bent one of them, at each end, I didn't catch that properly ... what was he doing that for? Or was that irrelevant?

 

[FromTheDarkness]

Anglefiremods seems to be the most cost efficient - as in not waiting 2 months for china

And they offer some decent modded kayfun, and extra parts for reasonable prices, and there is a 10% discount on this site

 

[blademansw]

When he had the 3 wires together Rip bent one of them, at each end, I didn't catch that properly ... what was he doing that for? Or was that irrelevant?

Thats to help him hold them in the drill chuck. I bent all of them :-)

Sent by Harbinger from the edge of the Apocalypse...

 

[scrumpox]

Thats to help him hold them in the drill chuck. I bent all of them :-)

Sent by Harbinger from the edge of the Apocalypse...

Cool, and once you've produced that twisted length, is it good for a single coil, or would you get a couple out of it? I mean, does it fray?

 

[blademansw]

Cool, and once you've produced that twisted length, is it good for a single coil, or would you get a couple out of it? I mean, does it fray?

You can normally get two or maybe 3 coils out of it, and it stays stable and twisted

Sent by Harbinger from the edge of the Apocalypse...