Mech advice

[cliveh2]

not used a mech mod before and haven’t used the bonza kit as of yet I still need to acquire some 21700 batteries.... as it will be my first time using hybrid mech device I just want to make sure I have a safe set up and build resistance ( dont wanna go and blow me hand off first time out lol )

So I appreciate any tips and advice.

This is what I did before my 1st mech.
Watch some stuff on you tube about mech safety
Always check my build on a regulated mod before putting the rda on a mech
Always check my battery wraps for rips etc
Only ever buy batteries from a trusted supplier (in my case fogstar) and use an ohms law calculator to make sure the batteries you are buying are suitable for the build you want
And ask on here there are lots of very knowledgeable apes on here

 

[cliveh2]

50 of those watts are gonna be lost inside the nerf tube so he might wanna build down to .2 to compensate for the voltage theft of the kit [emoji23]

I was going to recommend 0.15 but is that a bit close for a 1st time user?

And I thought it was a depth charge now not a nerf grenade [emoji23]

 

[mattyk2010]

I was going to recommend 0.15 but is that a bit close for a 1st time user?

And I thought it was a depth charge now not a nerf grenade [emoji23]

I'd have gone that little higher as he don't like a hot vape and it was a depth charge until he gave me it back [emoji23] now it's back to a nerf grenade on the promise they won't throw it at the neighbours again [emoji23] and props to vandy vape on construction cos even though it's been thrown about and been in a pond for 18 or so hours it still works the same as when I received it [emoji23] [emoji23]

 

[cliveh2]

I'd have gone that little higher as he don't like a hot vape and it was a depth charge until he gave me it back [emoji23] now it's back to a nerf grenade on the promise they won't throw it at the neighbours again [emoji23] and props to vandy vape on construction cos even though it's been thrown about and been in a pond for 18 or so hours it still works the same as when I received it [emoji23] [emoji23]

Yes sounds like 0.2 would be a good starting point
I can see a whole new review section starting up, mattyk's kids test/throw around mods till destruction [emoji6] [emoji23]

 

[WaitFor1t88]

props to vandy vape on construction cos even though it's been thrown about and been in a pond for 18 or so hours it still works the same as when I received it

That meaning it still hits proper wet then?

 

[mattyk2010]

That meaning it still hits proper wet then?

I'm struggling with the word hit to be honest mate more like a soft push [emoji23]

 

[Falcon Fx1]

That meaning it still hits proper wet then?

Thanks for the link just ordered my Samsung 21700 30Ts.