john john whaur ye gon
Postman
- Joined
- Jul 1, 2018
- Messages
- 273
Going to make some simple ss coils over weekend and try on the picco sq 2 this weekend in temp control,either single wire about 0.4 ohm in a drop solo or two of same in a dual recurve, to give 0.2ohm
Am i correct in tcr ss it will work away with the factory preset, but i can customise by putting a tcr value, in Memory M1,M2,orM3, and are each of these Memories alocated to that wire, ie ss in tcr is last setting in the three wires so should i use M3 or do i just put certain values in each memory and ensure i am using that memory when in tcr with that material, going to look at the tcr M when in ss and see if it highlights one of these memories indicating the one to use.
Read back poss answered my question,
Am i correct in tcr ss it will work away with the factory preset, but i can customise by putting a tcr value, in Memory M1,M2,orM3, and are each of these Memories alocated to that wire, ie ss in tcr is last setting in the three wires so should i use M3 or do i just put certain values in each memory and ensure i am using that memory when in tcr with that material, going to look at the tcr M when in ss and see if it highlights one of these memories indicating the one to use.
Read back poss answered my question,