Pico Squeeze

[LordOvSalem]

Morning everyone,

I apologise if this question has been asked a million times before, but struggling to find the answer that will give me that peace of mind I am getting the best out of this device.

I am loving my dripbox 160w but due the size and weight, I can't really take it out and about! I have purchased a squeeze and hadaly clone from FT (still awaiting for it to be dispatched) and just wanted to ask what builds people have been getting success with?

I normally dual build kanthal clapton/fused clapton coil on my other RBAs around 0.2/0.4, sat on dual battery mods, and normally vape in excess of ~60w. With the 50w cap on the squeeze and single coil on the hadaly this is new territory for me! Any advice as to how to get the most from this setup?

Also what batteries should I consider for best life? Fancy some 25rs, but happy to be told otherwise!

Thanks in advance, you friendly bunch

 

[leftism]

I run 0.5(ish) SS316L single wire micro coils in mine - fast ramp-up time and great flavour from the the Hadaly!

In the case of Batteries, usually I go with 25R or VCT5a but TBH i think it's likely overkill.

 

[mick brown]

Almost exactly as above. 0.5 ohm 26g stainless spaced with 25r's .

 

[burner]

Hybrid Ni 80 dual core wrapped in kanthal four wraps at 3mm .21 ramps up quickly and gives great flavour.
http://www.wireandstuff.co.uk/cgi-b...20----5-Metre-Spool---2.5-Ohms-m.html#SID=152

 

[LordOvSalem]

Have seen alot of SS316 hype for this tank, and I have always been intrigued by TC so getting some SS wire would be a good excuse to try that out on another mod.

 

[Bardiel003]

For single 18650, any battery would do (I think) and single coil be best. Like others has build said, I have the pulse 22 and I out in fused Clapton 26x32 and abiut 4-6 wraps and I get in the range if. 4-.5 ohms. And those would need low wattage not too high. 60w is a bit high, but it'll do just fine.

 

[eyeball kid]

Have seen alot of SS316 hype for this tank, and I have always been intrigued by TC so getting some SS wire would be a good excuse to try that out on another mod.

I've used spaced26awg/ 24awg 0.8ohm and stainless claptons 0.5 that I bought pre made from ud. All have delivered excellent flavour and plenty of vapour in the hadaly. It's a pretty universally good rta bud. For a little pocket rocket I think you will be pleased.

 

[LordOvSalem]

I've used spaced26awg/ 24awg 0.8ohm and stainless claptons 0.5 that I bought pre made from ud. All have delivered excellent flavour and plenty of vapour in the hadaly. It's a pretty universally good rta bud. For a little pocket rocket I think you will be pleased.

That is what I was looking for. A little mod I can take to and from work whilst not skimping out on the flavour! Stainless claptons may be my first start

Cheers everyone for the recommendations and help!

 

[anthonyb]

I to have the same set up, (squeeze - hadaly)
For me single straight 24 awg kanthal at 0.5 ohm (ish) on a 3mm bit, is perfect.

PS. a vtc5a lasts me most of the day.

 

[joe clay]

Same set up but 22g ni80 flatwire 4/5 wraps round 3 post...amazing