You can anneal it with a flame, mini blowtorch is ideal or a lighter.GRRRRAAHHHHHHHHAAA!! is there ANY way to make this less springy??
Like heat it up with a lighter and dip it in cold water or somethin?
It vapes amazing but my god...
That wont hurt it? Lighters n stuff r way higher than 600 degreesYou can anneal it with a flame, mini blowtorch is ideal or a lighter.
Unless you concentrate the flame in one spot you'll never get that hot. Plenty YT vids out there, used to be common to preheat wire prior to coiling.That wont hurt it? Lighters n stuff r way higher than 600 degrees
The melting point of SS316L is 2540-2630° F so start further away to reduce temp and then move closer to get desired result!
Quite probably just depends on if you want to dry heat or not.it’s no about it melting, heating wire until it glows causes changes in the structure that could be bad for the health. there is a farsalinos article about it, that recommends not dry burning coils. torching them with a blowtorch would have the same effect i’m sure.