Ohms all over the place

[DickyMounbatten]

Hi,
im having a time of it with my lavatube & SID Mods and the 3 rba's I've got, a cobra, aga t2 and rsst. All good until today, managed to get to the bottom of most problems so far with help of this forum and various YouTube posts. However, a perfectly working set of rba's went wonky, all showing 9.9 ohms.
I think it's a problem with the contact on the 2 mods, but, it something I've done, and I can't for the life of me think what.
i rebuilt the rsst this morning for a clean, have I put the post down too far and knackered the contacts on my 2 mods ?
i can get the ohms to a reasonable ( if unstable ) level by unscrewing the tank, it's a bit wobbly, but it fires.
Any help much appreciated.
Dicky.

 

[Grizzly Adams]

MMmm strange I had the same problem earlier on a I atty on a Z max, turned out I'd put the mod down a little hard on the table after sorting coil and filling, the mesh was touching the bottom of tank and the coil had found a clean spot, pulled the mesh up respaced and seated coil now all ok

 

[DickyMounbatten]

The Sid has an adjustable collar that can stop the wobble, so not all is lost. Even the volcanoe lavatanks are coming out stupid high. Think I've knackered it. Have messaged them just in case it's an easy fix.
Thanks for getting back.