Squonk newb question

[Deleted member 39468]

Hi peeps.
I've got my Pico squeeze and ready to take my first steps into the world of Squonking.

I got Narda and Hadaly clones that both come with the Squonk pin. I've swapped out the bottom screws with the pins. Do I need to use the little o-ring thingys in the rda packets or lock, load and Squonk away. Thanks for your help in advance x

 

[EmbraSewerRat]

You should just be able to swap out the pins and off you pop.

When you took out the original pin, was there an o-ring attached to it? if aye, then put it on the squonk pin, if no, get it right up it.

 

[city461]

You should just be able to swap out the pins and off you pop.

When you took out the original pin, was there an o-ring attached to it? if aye, then put it on the squonk pin, if no, get it right up it.

^^^ This... im not familiar with the clones but as @EmbraSewerRat above and you should be ok...

 

[EmbraSewerRat]

All my poor mans squonk atties, it has just been a simple matter of wheech one pin oot, whap the other right in there and off we toot.
Nae fannying about wi' ring pieces....

 

[Tubbyengineer]

For the Hadaly it's definetely just a case of changing the pin - Just lock and load...

 

[Deleted member 39468]

Thanks all for sharing your wisdom.

 

[eyeball kid]

Can confirm it's a straight swap with the narda too.

 

[Lord Grim]

I have a Narda from Fasttech, it's a decent enough atty, but I had to pack the pin out with two o rings from my bits box just to get a contact. And it's not the mod, I've tried it on several.

 

[eyeball kid]

I have a Narda from Fasttech, it's a decent enough atty, but I had to pack the pin out with two o rings from my bits box just to get a contact. And it's not the mod, I've tried it on several.

Mine went hand in glove. Probably the best most flush pin I've fitted. No fuss. I've got a nice 22mm goon lp yet to covert that I've high hopes for on the squeeze with a dual nichrome 0.5 ohm set up. Nice when I want to take a sub ohm setup out and about. The other three squeezes are set up for mtl with 1 .1ohm coils.

 

[Deleted member 39468]

Mine went hand in glove. Probably the best most flush pin I've fitted. No fuss. I've got a nice 22mm goon lp yet to covert that I've high hopes for on the squeeze with a dual nichrome 0.5 ohm set up. Nice when I want to take a sub ohm setup out and about. The other three squeezes are set up for mtl with 1 .1ohm coils.

Nice set up. I've only got one just now but I like the idea of different set ups. It's like espresso in the morning and latte in the afternoon