VapeCige VTBox200

[Tubbyengineer]

Ahhh that could be it. Yeh probably a good pack but I still stand by what I say, no way that thing would stand up to 100C!!!

well they claim to hand build them to order, but I'm as skeptical as you about the 100c claim, I'd like to see proof...

 

[TruckinVaper]

well they claim to hand build them to order, but I'm as skeptical as you about the 100c claim, I'd like to see proof...

That 1800mAh pack if the specs are right might just fit!!! I've sent them an email with some probing questions. Might be worth it after all

 

[Tubbyengineer]

That 1800mAh pack if the specs are right might just fit!!! I've sent them an email with some probing questions. Might be worth it after all

It might be 1mm too thick, I make the battery compartment 25.5mm deep from the backplate to the very top of the compartments lip, but it should be OK width and length wise...

 

[andy clem]

VT box DNA200 by VapeCige

Ever close that the bigger pack will fit we measured up and there's only a mil or so over but the depth of our vt box varies from depth slightly along from side to side. Me and my mate were wondering wether to go for the bigger battery [emoji12] please re post your findings . There is a bit of a recess under the lid too so maybe just maybe .?

 

[popeye]

Thanks for pointing this thread out Andy

 

[andy clem]

Your welcome buddy [emoji12][emoji100][emoji100]

 

[Tubbyengineer]

Ever close that the bigger pack will fit we measured up and there's only a mil or so over but the depth of our vt box varies from depth slightly along from side to side. Me and my mate were wondering wether to go for the bigger battery [emoji12] please re post your findings . There is a bit of a recess under the lid too so maybe just maybe .?

I've measured the box at 3 points on each axis, results are to closest Half mm, 25.5 x 35 x 78, the spare depth in the lid averages at 1.2mm, dont forget you'll need to leave a bit of room in the long axis for the connectors...

 

[andy clem]

I've measured the box at 3 points on each axis, results are to closest Half mm, 25.5 x 35 x 78, the spare depth in the lid averages at 1.2mm, dont forget you'll need to leave a bit of room in the long axis for the connectors...

Thank you very much for that sir. I will be putting your findings to my vapour friend tomorrow and be carefully mulling over our decision as to which battery to go for. Ideally the 1800mah . We shall see .[emoji12]thanks again and a very good night to you [emoji12][emoji100][emoji100][emoji106]

 

[Tubbyengineer]

Thank you very much for that sir. I will be putting your findings to my vapour friend tomorrow and be carefully mulling over our decision as to which battery to go for. Ideally the 1800mah . We shall see .[emoji12]thanks again and a very good night to you [emoji12][emoji100][emoji100][emoji106]

If you wnt to be really sure get some polystyrene or layers of card and mock up a block the size of the battery - then test fit it to see what you get...

 

[andy clem]

If you wnt to be really sure get some polystyrene or layers of card and mock up a block the size of the battery - then test fit it to see what you get...

Thanks for your suggestion. That's got to be the way forward before taking the plunge[emoji12][emoji106]