Big Kev
Achiever
- Joined
- Apr 13, 2014
- Messages
- 1,196
I've had this clone for about a month and have experienced wild ohm readings, with four different coils.
The reading can be 1.4ohm when installed, but once liquid get in there, it goes up to silly readings, like 5.6, 3.6 or I get the "check atomizer" reading on my Hana. I've also checked these with my ohms meter and they are roughly the same.
The screws are tightened securely, no coil movement when moving the legs about before clipping and the coil above the hole nicely, not touching anything.
I've never had this problem with my Heron, Rose, Fogger, Plume, Magma etc, so I'm rather stumped at the moment. It still vapes fine, but is very annoying.
The reading can be 1.4ohm when installed, but once liquid get in there, it goes up to silly readings, like 5.6, 3.6 or I get the "check atomizer" reading on my Hana. I've also checked these with my ohms meter and they are roughly the same.
The screws are tightened securely, no coil movement when moving the legs about before clipping and the coil above the hole nicely, not touching anything.
I've never had this problem with my Heron, Rose, Fogger, Plume, Magma etc, so I'm rather stumped at the moment. It still vapes fine, but is very annoying.
Last edited:
