joe o sullivan
Initiate
- Joined
- Sep 14, 2019
- Messages
- 43
This morning my Smok Devilkin displayed an "Ohms too high" error when using my Profile Unity.
Generally the resistance is about 0.15 ohms.
I took the unity apart and made sure the screws were tight and the mesh wasn't burned out or anything, and put it back together, and it read 0.7 ohms, then a few minutes later it dropped to 0.5, then after another few minutes it displayed the warning and stopped working again, but still reading about 0.5 ohms.
When it was reading high, the vape was quite warm even at low power (the vape is generally very chilly from it).
Is this just a burned out coil? I've never had one yet...
It seems fine, it's a coil (well, a mesh) that I used a few weeks ago, that I just swapped out when changing the cotton, and I gave it a soak and a clean and put it back in the box.
Thoughts?
Generally the resistance is about 0.15 ohms.
I took the unity apart and made sure the screws were tight and the mesh wasn't burned out or anything, and put it back together, and it read 0.7 ohms, then a few minutes later it dropped to 0.5, then after another few minutes it displayed the warning and stopped working again, but still reading about 0.5 ohms.
When it was reading high, the vape was quite warm even at low power (the vape is generally very chilly from it).
Is this just a burned out coil? I've never had one yet...
It seems fine, it's a coil (well, a mesh) that I used a few weeks ago, that I just swapped out when changing the cotton, and I gave it a soak and a clean and put it back in the box.
Thoughts?