The return to MTL and restricted lung vaping

[dalk1210]

Just got my Kayfun V3 mini clone from FT but something is causing a short . Anyone else had this with the clone ?

 

[JohnnyAce]

Yes, by the looks of it it could be your centre block. It looks on the wonk & if that touches anything it shouldn't it'll short

Is it tightened down or does it move?

 

[domejunky]

Just got my Kayfun V3 mini clone from FT but something is causing a short . Anyone else had this with the clone ?View attachment 93164View attachment 93165

Your positive post (furthest from the camera in the second shot) looks like it could be skewed. Might be tiuching the side of the deck...

 

[dalk1210]

 

[dalk1210]

Should be in line with the insulator ?
How do I straighten up ?

 

[dalk1210]

Sorry it's tight it's not loose .

 

[JohnnyAce]

Underneath the base section (the bit that comes out with the 510 pin) there's a nut around where the Airflow control screw is, you can use a pair of pliers to adjust it. Loosen it off & it'll free the positive block to move into place then tighten it up to set it

There's a picture around somewhere where someone explains it better than I did, I'll see if I can find it

ETA: Here https://www.planetofthevapes.co.uk/...on/threads/kayfun-mini-v3-clone.105416/page-2

 

[dalk1210]

Ok great will try that thanks for your help [emoji106][emoji4]

 

[dalk1210]

Hi working great now thanks

 

[JohnnyAce]

Good stuff, enjoy