Just tried my first dripper.....wow!

[vaporsizer]

so this morning I had a nemesis clone and an Omega clone delivered. Over the past few weeks I've been using my provari mini and KFL+. I'm at work at the moment on a night shift and I've been coiling in the kitchen. I wrapped a 1.2 ohm coil and used cotton wool and nervously fired it up. Thankfully my face is still intact but wow what a vape. I think the kayfun tastes great but this is something else. I am very happy

Nice one mate. Just take your time with your builds, no rushing them & keep things tidy in there. Don't pack your cotton too tight in the coils & if in doubt, keep it at 1ohm & above. Keep the wicks wet. It's like a whole new world of vaping man, looking good !!!

 

[bakedclouds]

Sorry double post
Did you get magnets with your nem?

I bought this off 5miley and he included magnets. I believe vapegeek.co.uk include free magnets with every nem clone

 

[bakedclouds]

Nice one mate. Just take your time with your builds, no rushing them & keep things tidy in there. Don't pack your cotton too tight in the coils & if in doubt, keep it at 1ohm & above. Keep the wicks wet. It's like a whole new world of vaping man, looking good !!!

thanks mate. yea I'm not going to sub ohm with these batteries.

 

[bakedclouds]

same setup as mine, vapes like a dream, thicker wire has been a problem on the Omega clone though for me, Double/Triple/Quad twist is ok just not in dual coil mode, damn screw heads are too small lol

is your omega a Hcigar one? the 510 pin on the my omega seems too long and doesn't sit flush on the nemesis. Do you have this problem? I think you can see the gap in the picture I uploaded

 

[RSJFT]

Perv lol

You think THATS pervy? you should see what I have them talking about on the 'Side Effects' thread...

 

[VeeDubZ]

is your omega a Hcigar one? the 510 pin on the my omega seems too long and doesn't sit flush on the nemesis. Do you have this problem? I think you can see the gap in the picture I uploaded

No its a vapetech one from Grey Haze, it also had the same problem, think it was the last thread was closed or not machined fully, a bit of gentle persuasion was needed to screw past it, only took a few minutes just be gentle but firm with it.

Sent from my HTC One using Planet of the Vapes mobile app