Ni200 coil building advice
- Thread starter gstar
- Start date
gstar
Postman
- Joined
- Nov 21, 2015
- Messages
- 205
@danb just tried the coil again. This time I adjusted the wattage to 25. Not harsh at all. Works well. Think I will re build the coil because of ohms didn't quite come out right..but with a wattage down I was able to put up the temp to 250 and it still works a treat.
Thanks for advice. I'll keep coiling!
Thanks for advice. I'll keep coiling!
hi
You got to bring the nic levels down im down from 18 to 3mg
I've played around with various nickle builds from various vendors but finally realised its all down to basics.
1. Get the spaced coil on the deck check resistance is not locked
2. Gently strum the wire as will tell u if coils in tight and not connected ! before u try wicking, as nickle is soft or becomes softer as u reheat it
3 note the res. not changed if it has check the post as it dances off the post screws, if need be strum it before u prime and ur tuned in
Finally do a pulse hit as ur juice will show sizzle then u can lock the resistance !
start at 200 F as 200 c is more than double in conversion as u go up in temp u will find the sweet spot happy vaping
You got to bring the nic levels down im down from 18 to 3mg
I've played around with various nickle builds from various vendors but finally realised its all down to basics.
1. Get the spaced coil on the deck check resistance is not locked
2. Gently strum the wire as will tell u if coils in tight and not connected ! before u try wicking, as nickle is soft or becomes softer as u reheat it
3 note the res. not changed if it has check the post as it dances off the post screws, if need be strum it before u prime and ur tuned in
Finally do a pulse hit as ur juice will show sizzle then u can lock the resistance !
start at 200 F as 200 c is more than double in conversion as u go up in temp u will find the sweet spot happy vaping
Btw ... as these wires get hotter quicker due to lower res. and higher wattages make sure u leave plenty of room under the coil for air flow as they need to cool down as quick, also I use little less cotton than I do on kanthal
I tried subtank couldn't find any joy with stock or RBA but im mtl cant do lung hits lol I went to my fav build decks got few kayfuns
got sum ti and ss 316L wire coming so will try that soon
I tried subtank couldn't find any joy with stock or RBA but im mtl cant do lung hits lol I went to my fav build decks got few kayfuns
got sum ti and ss 316L wire coming so will try that soon
Similar threads
