@Tazz @Martin Dadley
Vics vid on this is pretty good so not much more to say really.
Its built to very tight tolerances meaning it fits so snug all over ive been struggling with air replacement.
The mesh strips that come with it are not quite what they should be for example the 0.11ohm one came out at 0.9ohms and as i had already ditched the other one which actually read 0.11ohms it was onto a roll of mesh from VV.
After trying with ghe provided strips building all ways with what i thought was too much then too little cotton i ended up cutting a strip of VV ni80 mesh to the same size as the strips which came out at 0.06ohms.
To get anywhere with a 0.06 build I've ended up having to use a full labo puff pad as the wick.
It will puff at 75w but its only pushing just over 2v so not really vaporizing the juice very well so pushing it as high as possible (90w) till it verges on dry hitting it can't keep up as the vacuum is preventing juice replacement.
Ordered some 0.2ohm kylin m strips which should suit me better.
Not convinced on vics wicking method although it makes sense ive found wicking the wells like i normally would (just enough in the well entrance only) is much better.
I'd say I've not nailed it yet but not far off and convinced it will be great ill continue the preorder purchase from FT which still hasn't shipped yet.