Does anyone else work with SS for coil building?

[MilesDeep]

I've been using stainless since the beginning. It's what I first with because of the flavor compared to A1.

Anyway, I was wondering or hoping some had a way of being able to increase the resistance of the build. My problem being that I use dual coil setups. I built a dual parallel coils using (28ga+32ga)*24ga+0.1*0.5 super juggernaut 316L Stainless. But yeah, barely any resistance...though you can tell I was able to get some heat to them for a break in.

This same build done in a single wrap instead of parallel hits in a beautiful range for my preference in TC gaping.

Any thoughts or options would be much welcomed.
Vape it up!

 

[stevoknevo]

Wrap it as a single coil instead of parallel, that'll double the resistance right away but to be honest, you have so much metal there that it'll take an age to ramp regardless. You need a mod capable of supplying more power to be able to fire coils like you have currently.

 

[MilesDeep]

Wrap it as a single coil instead of parallel, that'll double the resistance right away but to be honest, you have so much metal there that it'll take an age to ramp regardless. You need a mod capable of supplying more power to be able to fire coils like you have currently.

Thanks. I want to try staged coils. The mod in the pic was only being used to break in the coils at a very low wattage. So far I haven't had issue with powering two coils, however this was a first parallel build with this type of wire.

 

[MilesDeep]

Thanks. I want to try staged coils. The mod in the pic was only being used to break in the coils at a very low wattage. So far I haven't had issue with powering two coils, however this was a first parallel build with this type of wire.

Wrapped as single.