JackDinn
Postman
- Joined
- May 27, 2014
- Messages
- 101
Hi,
So i got my KFL Russian 98% a couple of weeks ago now and all i get is a burned taste (yea you have all heard it before). I must have built 40 or 60 different builds now ,
Pulling my hair out now
Its got to be something with this cheep kayfun clone i got but what ?
How do i know if the channels need dremaling out a bit so the juice can keep up?
Why does my coil seem so close to the top of the chamber , almost flush with the chambers top and touching the chimney lid ? is my chamber shorter than it should be? The top of my chamber (not chimney) is exactly half way up the plastic tank section but others iv seen the chamber goes all the wy up and you an hardly see the beginning of the chimney lid. Is the lid being so close to the coil kinda "bouncing the heat" back down and burning the wick as the wick is always burned on top?
I suspect it's the channels and the juice flow just cant keep up but im not sure.
I suppose thats what you get for buying a £22 kayfun, might even just buy another if i cant figure this one.
So please any advise would be great (although keep in mind iv watched just about all the vids and read all the help available).
Cheers.
So i got my KFL Russian 98% a couple of weeks ago now and all i get is a burned taste (yea you have all heard it before). I must have built 40 or 60 different builds now ,
- Kanthal from 0.32mm to 0.15
- coil diameter from 1.5mm to 3mm
- coil resistance from 1.2 to 4 ohms
- wick (always boiled cotton) from extremely loose to twisted tight
- Wick very fine across the deck to thick on deck (always sure to not block up channel holes)
Pulling my hair out now
Its got to be something with this cheep kayfun clone i got but what ?
How do i know if the channels need dremaling out a bit so the juice can keep up?
Why does my coil seem so close to the top of the chamber , almost flush with the chambers top and touching the chimney lid ? is my chamber shorter than it should be? The top of my chamber (not chimney) is exactly half way up the plastic tank section but others iv seen the chamber goes all the wy up and you an hardly see the beginning of the chimney lid. Is the lid being so close to the coil kinda "bouncing the heat" back down and burning the wick as the wick is always burned on top?
I suspect it's the channels and the juice flow just cant keep up but im not sure.
I suppose thats what you get for buying a £22 kayfun, might even just buy another if i cant figure this one.
So please any advise would be great (although keep in mind iv watched just about all the vids and read all the help available).
Cheers.
Last edited: